K12 - DESIGN OF MOORING AND ANCHORING

This Appendix includes results from static GeoSuite Stability calculations for the profiles shown in Figure 1-1.. The stability calculations are performed with both undrained and

Prepared by: Johannes Mydland Controlled by: Knut-Helge Bergseth Approved by: Kolbjørn Høyland. CONCEPT DEVELOPMENT FLOATING BRIDGE

This Enclosure shows stability checks of the back columns and tower of the cable stayed bridge for critical construction stages and the complete states.. Reference is made to

In the following effective areas and effective wind areas (including drag factors) are calculated for the climbing formwork at the top of the axis 1E column. These parameters apply

Preferred solution, K12 – main report 3 Description, evaluations and risk assessment of K12 base case solution The overall roll stability of the high part of floating bridge

The effect of the proximity of the sea surface on the aerodynamic load coefficients was investigated separately in a wind tunnel test where the deck section was set close to the

The above procedure is illustrated in the example below which pairs the aerodynamic derivatives shown in Figure 3.2 with the structural properties of Storebælt East bridge

Concept development, floating bridge E39 Bjørnafjorden. Appendix G –