Noise Robust Surface Reconstruction by Combining PU and Graph-cut

The system can be implemented as follows: A web-service client runs on the user device, collecting sensor data from the device and input data from the user. The client compiles

The dense gas atmospheric dispersion model SLAB predicts a higher initial chlorine concentration using the instantaneous or short duration pool option, compared to evaporation from

Figure 5.3 Measured time series of the pressure for HK 416 N at two different directions from the shooting direction, with and without flash suppressor, at 84 cm from the muzzle..

• Combining the most silent tyre with the most silent road surface in this investigation gives a potential noise reduction of approximately 6 dB(A) of the rolling noise levels,

As an input to the SPERoN tyre/road noise model, noise and texture measurements have been performed on a selection of typical Norwegian road surfaces.. The noise from one

Our algorithm deforms a closed oriented pseudo-surface embedded in the 3D Delaunay triangulation of the sampled points, and the reconstructed surface consists of a set of

We start by computing a low res- olution surface reconstruction from roughly aligned scans (which we expect as input) and use this surface as a pro- totype surface to align all

We use a suitable robust, noise-resistant skeletonization algorithm to extract the full 3D skeleton of the given surface, and subsequently compute a surface classifier that