• No results found

Resistance sensor employing thermophoresis for soot in diesel exhaust

N/A
N/A
Protected

Academic year: 2022

Share "Resistance sensor employing thermophoresis for soot in diesel exhaust"

Copied!
1
0
0

Laster.... (Se fulltekst nå)

Fulltekst

Referanser

RELATERTE DOKUMENTER

This paper presents a concept where the exhaust gas of the gas turbine is recirculated (EGR) such as to deplete the air of oxygen to produce a low temperature combustion with

An evaluation was made of the impact the aluminum exhaust gas may have on the gas turbine and it is estimated that the most critical issues are corrosion due to SO 2 in the

A plot of a typical temperature distribution for a sensor device with cap is shown in Figure 5. One can observe that the temperature is lower for the sensor substrate than for the

The aim of the current study was to develop a thermal design that would lower the temperature on the sensor surface as much as possible, relative to the hot exhaust gases and thus

Based on the measured gaseous sulfuric acid (GSA) and non-volatile core and soot particle number concentrations of the raw exhaust, the model simulations showed that the best

During the past years the exhaust emissions from new gasoline and diesel vehicles have been reduced to very low levels due to improved engine technology, exhaust after

Detailed physicochemical characteriza- tions of diesel exhaust particles were performed to investigate how the composition of three types of DEPs affects their bio- logical effects

Baulig et al., “Organic compounds from diesel exhaust particles elicit a proinflam- matory response in human airway epithelial cells and induce cytochrome p450 1A1 expression,”